CD74HC4066E Overview
Presented in 14-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. Advanced packaging method Tube is used to provide high reliability. Through Hole is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -55°C~125°C TA. Totally, there are 14 terminations. As a result of its 4 channels, this electronic component provides high-quality output. A 4.5V voltage supply should turn on and run the electronic component. An electrical component like this is included in the 14 series. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching for 74HC4066 variants of the analog switch ic. Internally, this switch multiplexer has a resistance of 70Ohm. Please refer to the datasheets for 14 pins functions. The analog multiplexer shown here is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 10V. Analogue multiplexers of the Single supply type that are cost-effective. 2V is the lowest voltage that should be fed to the electronic electronic part. A voltage of 2V~10V is required to drain this analog switch from a single voltage supply. Put voltage above 16μA on the multiplexer to cause damage. 200MHz bandwidths enable data to be transferred.
CD74HC4066E Features
4 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz
CD74HC4066E Applications
There are a lot of Texas Instruments CD74HC4066E Analog Switches & Multiplexers ICs applications.
- Microprocessor controlled systems
- Residential Gateways, Home Gateway/Router
- Data Acquisition Systems
- Channel Banks
- Mechanical reed relay replacement
- Industrial and process control systems
- Intelligent PBX
- Multiplexers
- Precision instrumentation
- Battery Powered Instruments
