CD4013BNSR Overview
In the form of 14-SOIC (0.209, 5.30mm Width), it has been packaged. D flip flop is included in the Cut Tape (CT)package. There is a Differentialoutput configured with it. This trigger is configured to use Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 3V~18V. A temperature of -55°C~125°C TAis used in the operation. There is D-Type type of electronic flip flop associated with this device. The 4000Bseries comprises this type of FPGA. It should not exceed 24MHzin its output frequency. There is a consumption of 4μAof quiescent energy. There are 14 terminations,The CD4013family includes it. A voltage of 5V is used as the power supply for this D latch. A JK flip flop with a 5pFfarad input capacitance is used here. There is an electronic part mounted in the way of Surface Mount. This board is designed with 14pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. Normally, the supply voltage (Vsup) should be above 3V. Its superior flexibility is attributed to its use of 2 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. Featuring the maximum design flexibility, it has an output current of 6.8mA . It operates with 1 output lines. There is a consumption of 20μAof quiescent current from it.
CD4013BNSR Features
Cut Tape (CT) package
4000B series
14 pins
CD4013BNSR Applications
There are a lot of Texas Instruments CD4013BNSR Flip Flops applications.
- Balanced 24 mA output drivers
- Bus hold
- Set-reset capability
- Event Detectors
- Automotive
- Instrumentation
- Frequency Dividers
- Storage Registers
- Modulo – n – counter
- Pattern generators
