BUF11704AIPWPG4 Overview
A HTSSOP EP case is used to package the op amp. BUFFER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Rail/Tube case. It is estimated that there will be 28 terminations in the next few months. There are a total of 28 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 18V volts. It should be noted that this op amp is a type of Buffer Amplifier device. There are 28 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 30mV. An 5mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. In order for op amp to function properly, the temperature should not be lower than -25°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 85°C. There are a total of 10 elements in this linear amplifier. I would like to point out that this electrical component is capable of working from a voltage below 18V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 7V at all times.
BUF11704AIPWPG4 Features
28 Pins
supply voltage of 18V
0.004dB voltage gain
BUF11704AIPWPG4 Applications
There are a lot of Texas Instruments
BUF11704AIPWPG4 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
