74ALVTH16374ZQLR Overview
In the form of 56-VFBGA, it has been packaged. The package Tape & Reel (TR)contains it. The output it is configured with uses Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. A voltage of 2.3V~2.7V 3V~3.6Vis used as the supply voltage. It is operating at a temperature of -40°C~85°C TA. The type of this D latch is D-Type. JK flip flop belongs to the 74ALVTHseries of FPGAs. Its output frequency should not exceed 250MHz. The element count is 2 . 56terminations have occurred. The object belongs to the 74ALVTH16374 family. The power supply voltage is 2.5V. The input capacitance of this JK flip flopis 3.5pF farads. It is mounted in the way of Surface Mount. The 56pins are designed into the board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The part is included in FF/Latches. An electronic part with 16bits has been designed. Considering the reliability of this T flip flop, it is well suited for TR. The D flip flop is embedded with 2ports. Its output current of 64mAallows for maximum design flexibility. There are 8 output lines on it. It consumes 100μA of quiescent current without being affected by external factors. Additionally, you may refer to the D latch's additional ALSO OPERATES AT 3.3V SUPPLY.
74ALVTH16374ZQLR Features
Tape & Reel (TR) package
74ALVTH series
56 pins
16 Bits
74ALVTH16374ZQLR Applications
There are a lot of Texas Instruments 74ALVTH16374ZQLR Flip Flops applications.
- Bus hold
- Matched Rise and Fall
- Balanced 24 mA output drivers
- Balanced Propagation Delays
- Storage Registers
- Common Clocks
- Safety Clamp
- Consumer
- Test & Measurement
- Power down protection
