5962-9460206Q2A Overview
Packaged in a LCC case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Rail/Tube case. There is a growing number of terminations approaching the number of 20. The pins on this board total to 20 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 20 pins are present on the instrumentation amplifier. There is an input offset voltage of 3mV for this buffer op amp. 106dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 19V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 19V volts.
5962-9460206Q2A Features
20 Pins
supply voltage of 5V
106dB voltage gain
5962-9460206Q2A Applications
There are a lot of Texas Instruments
5962-9460206Q2A Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
