5962-8765901CA Overview
In the package, you will find a CDIP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the COMPARATOR-type. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Comparator device, to be precise. The op amp ic has an array of 14 pins on it. Op amp rates 5mV as input offset voltage. On the buffer amps, there are 4 channels that can be used. Buffer amplifier produces OPEN-DRAIN signals, which is one of its many benefits. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. The linear amplifier is packaged by using a TUBE axis. This electric component can work from a voltage of under 16V as far as supply voltage is concerned. A voltage of 4V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 8V volts when you conduct this part.
5962-8765901CA Features
14 Pins
supply voltage of 5V
Output Type: OPEN-DRAIN
5962-8765901CA Applications
There are a lot of Texas Instruments
5962-8765901CA Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
