TSX562IQ2T Overview
Op amp is packaged in 8-WFDFN case. General Purpose-type instrumentation amplifiers are used in this application. A Tape & Reel (TR) case is used for delivering the op amp. There have been a total of 8 terminations over the past year. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 3.3V. In order to be more specific, this instrumentation amplifier is one of the types of Operational Amplifier devices. It has 8 pins that make up the linear amplifier. Op amp ic rates 1mV for input offset voltage. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is important to note that this linear amplifier works well at a temperature of -40°C~125°C when it comes to operating temperatureUsing a supply current of 250μA , this buffer op amp will be able to operate. Maintain 85dB as the voltage gain. The op amp ic has 2 channels on it. A TAPE AND REEL-shaped amplifier is used to pack the buffer amps.
TSX562IQ2T Features
supply voltage of 3.3V
85dB voltage gain
TSX562IQ2T Applications
There are a lot of STMicroelectronics TSX562IQ2T Instrumentational OP Amps applications.
- Mobile phone
- Band-pass filter
- Tablets
- Industrial applications including automation
- Micro signal measurement
- single/dual op amp sum and difference circuits
- Measurements of Wheatstone bridge
- Television
- Vehicle electronics
- Proportional counter tubes
