TSU104IPT Overview
It is packaged in an 14-TSSOP (0.173, 4.40mm Width)-case that protects the operational amplifiers from damage. This is a General Purpose type op amp. A Cut Tape (CT) case is used to deliver the buffer op amp. During the past two weeks, there have been close to 14 terminations. The linear amplifier should be run at 1.8V at all times, so please keep that in mind when using it. This particular linear amplifier is a type of Operational Amplifier device, to be precise. There are 14 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 100μV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . An 650nA volt supply current is needed for this linear amplifier to operate. It is recommended to keep the voltage gain at 130dB at all times. A instrumentation amplifier like this has 4 circuits. On the output type, there are Rail-to-Rail different types of op amps.
TSU104IPT Features
supply voltage of 1.8V
130dB voltage gain
Output Type: Rail-to-Rail
TSU104IPT Applications
There are a lot of STMicroelectronics TSU104IPT Instrumentational OP Amps applications.
- High gain DC amplifier
- Polarized electrodes
- Large motor controllers
- Comparator
- Switching amplifier
- Proportional counter tubes
- Power control
- pH (acidity)
- Signal transformation
- Voltage regulation circuit
