TSM104WAIN Overview
Packaged in a 16-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. There are two types of operational amplifiers in this circuit. There is a Tube case that is delivered with the instrumentation amplifiers. It is estimated that there will be 16 terminations in the next few months. In this case, there are 16 pins on the board. Please take in mind that this instrumentation amplifier should be run at 5V. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 16 pins on it. The input offset voltage is 3mV. For this electronic part, it is recommended that you mount it with type Through Hole. The buffer amplifier functions well at -40°C~105°C as far as operating temperature is concerned. It is possible to operate this buffer amplifier from a supply current of 1.4mA . Voltage gain should remain at 100dB. There is an operating supply voltage rating of 4 for this operational amplifier, which is rated at the manufacturer. The operating supply voltage of the buffer op amp is rated at 15V.
TSM104WAIN Features
16 Pins
supply voltage of 5V
100dB voltage gain
TSM104WAIN Applications
There are a lot of STMicroelectronics TSM104WAIN Instrumentational OP Amps applications.
- Exponential operation circuits
- Scintillation detectors
- Test equipment
- Weak signal detection
- Image computer boards
- Radar
- E-book readers
- Semiconductor detectors
- RF cable systems
- Portable media players
