TSH330IDT Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. Current Feedback-type instrumentation amplifiers are used in this application. A Tape & Reel (TR) case is used to deliver the buffer op amp. It is estimated that there will be 8 terminations in the next few months. The total number of pins on linear amplifier is 8. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 2.5V. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. 8 pins are available on the instrumentation amplifier. The input offset voltage is 3.1mV. Surface Mount is the recommended mounting type for this linear amplifier. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~85°C. An 16.6mA volt supply current is needed for this linear amplifier to operate. There is a rating of 1 for the operating supply voltage of the buffer op amp. The operating supply voltage of the buffer op amp is rated at 5V. It is used TAPE AND REEL to pack the op amps.
TSH330IDT Features
8 Pins
supply voltage of 2.5V
TSH330IDT Applications
There are a lot of STMicroelectronics TSH330IDT Instrumentational OP Amps applications.
- Strain gauges
- Scintillation detectors
- Proportional counter tubes
- Polarized electrodes
- pH (acidity)
- Video data acquisition
- Laptop
- Inverse/same-phase proportional circuit
- Television broadcasting equipment
- Medical instruments
