TL084BCPT Overview
There is a 14-TSSOP (0.173, 4.40mm Width) case in which the instrumentation amplifier is packaged. A J-FET-type buffer amplifier is shown here. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. It is estimated that there will be 14 terminations in the next few months. There are a total of 14 pins on this op amp. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. 14 pins are included on the operational amplifiers. Regarding input offset voltage, buffer amplifier rates 1mV voltage. This electronic part is best mounted with type Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of 0°C~70°C. An 1.4mA volt supply current is needed for this linear amplifier to operate. Maintain 106.02dB as the voltage gain. On this instrumentation amplifier, there are 4 circuits that are connected together. This linear amplifier pack is based on the TAPE AND REEL axis.
TL084BCPT Features
14 Pins
supply voltage of 15V
106.02dB voltage gain
TL084BCPT Applications
There are a lot of STMicroelectronics TL084BCPT Instrumentational OP Amps applications.
- Large motor controllers
- Polarized electrodes
- Integrator circuits
- Inverse/same-phase proportional circuit
- Automation control systems
- Communication
- Semiconductor detectors
- Power control
- Automatic control
- RF cable systems
