TL082IDT Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp ic of the J-FET type. The op amp is delivered to you in a Cut Tape (CT) case. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 10mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~105°C . As long as the supply current of the chip does not exceed 1.4mA, this op amp ic can operate. 106.02dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. The operating supply voltage of the buffer op amp is rated at 18V. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted.
TL082IDT Features
8 Pins
supply voltage of 15V
106.02dB voltage gain
TL082IDT Applications
There are a lot of STMicroelectronics
TL082IDT Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
