Name: STG719CTR
Brand: STMicroelectronics
SKU: STG719CTR
Availability: InStock

Technical Specifications

Parameter Name	Value
Type	Parameter
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	SOT-23-6
Number of Pins	6
Operating Temperature	-55°C~125°C TA
Packaging	Tape & Reel (TR)
Part Status	Obsolete
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	6
Resistance	4Ohm
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Number of Functions	1
Supply Voltage	3.3V
Terminal Pitch	0.95mm
Base Part Number	STG719
Pin Count	6
Number of Channels	1
Number of Circuits	1
Max Supply Voltage	5.5V
Min Supply Voltage	1.8V
Operating Supply Current	1μA
Nominal Supply Current	1nA
Max Supply Current	1μA
Turn On Delay Time	10 ns
Supply Type	Single
Bandwidth	200MHz
Turn-Off Delay Time	5.5 ns
On-State Resistance (Max)	4Ohm
Multiplexer/Demultiplexer Circuit	2:1
Off-state Isolation-Nom	74 dB
Current - Leakage (IS(off)) (Max)	250pA
Channel Capacitance (CS(off), CD(off))	19pF
On-state Resistance Match-Nom	0.1Ohm
Switch Circuit	SPDT
Switch Time (Ton, Toff) (Max)	7ns, 4.5ns (Typ)
Channel-to-Channel Matching (ΔRon)	100m Ω
Crosstalk	-52dB @ 1MHz
Switch-off Time-Max	8.5ns
Voltage - Supply, Single (V+)	1.8V~5.5V
Length	2.9mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

STG719CTR Product Details

STG719CTR Overview

Presented in SOT-23-6, this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 2:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -55°C~125°C TA degrees Celsius. 6 terminations have been made so far. High-quality output is provided by the electronic component's 1 channels. When the electronic component is given a voltage of 3.3V, it should be turned on and run. This electrical component is included in the 6 series of products. These analog multiplexers are built based on SPDT switching circuits. 1 circuits are used in this analogue multiplexer. Try searching with STG719 if you're looking for variants. The internal resistance of this digital multiplexer is 4Ohm. The datasheets for the 6 pins explain the functions. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. A cost-effective Single supply type analogue multiplexer. A low voltage of 1.8V should be applied to the electronic component. For this digital switch to work, 1μA current would suffice. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 1μA. This switch operates within the bandwidth of 200MHz.