STG6384QTR Overview
Presented in 10-UFQFN, this electrical component is convenient for overseas shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -40°C~85°C TA degrees Celsius. There are 10 terminations totally. This electronic part offers high-quality output due to its 1 channels. Powered by a 1.8V voltage supply, the electrical part should be switched on and run. An electrical component like this is included in the 10 series. These analog multiplexers are built based on SPST - NO switching circuits. Circuits number 2 make up this analogue multiplexer. Use STG5684 to search for variants of the digital switches. In this multiplexer, the internal resistance is 10mOhm. Datasheets for functions of 10 pins are available. A analogue multiplexer of this type is a Multiplexer or Switches. In normalcircumstances, users should not exceed 4.3V volts for the multiplexer. A analog switch ic that has a cost-effective Single supply type. There should be 1.65V voltage fed to the electrical part below 1.65V. 50nA current would be enough for this multiplexer to operate. The voltage required by this switch device is 1.65V~4.3V, draining from a single voltage supply. When the digital multiplexer is charged above 50nA, damage can occur. In this switch multiplexer, there are SEPARATE OUTPUT outputs available.
STG6384QTR Features
1 Channels
Switch Circuit: SPST - NO
50nA Supply Current
-3db Bandwidth: 65MHz
STG6384QTR Applications
There are a lot of STMicroelectronics STG6384QTR Analog Switches & Multiplexers ICs applications.
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Cross Connects
- E1 Multiplexer
- Access Concentrators
- DSLAMs
- Relay Replacement
- CSU
- Sample hold systems
- Automotive applications
