ST7FLITE09Y0B6

ST7FLITE09Y0B6 Description

The ST7FLITE09Y0B6 belongs to the ST7 family of microcontrollers. Every ST7 device is built around an 8-bit core that is the 8-bit industry standard and has an improved instruction set.

The FLASH memory in the ST7LITE0x and ST7SUPERLITE supports byte-by-byte In-Circuit Programming (ICP) and In-Application Programming (IAP).

The ST7LITE0x and ST7SUPERLITE devices can be set to WAIT, SLOW, or HALT mode under software control, which lowers the power consumption when the application is idle or in the standby state.

Software developers have power and flexibility because of the ST7's increased instruction set and addressing modes, which allow for the creation of incredibly efficient and small application code. All ST7 microcontrollers include actual bit manipulation, 8x8 unsigned multiplication, and indirect addressing modes in addition to ordinary 8-bit data management.

ST7FLITE09Y0B6 Features

• 1 Communication Interface

– SPI synchronous serial interface

• A/D Converter

– 8-bit resolution for 0 to VDD

– Fixed gain Op-amp for 11-bit resolution in 0 to 250 mV range (@ 5V VDD)

– 5 input channels

• Instruction Set

– 8-bit data manipulation

– 63 basic instructions with illegal opcode detection

– 17 main addressing modes

– 8 x 8 unsigned multiply instruction

• Development Tools

– Full hardware/software development package

• Memories

– 1K or 1.5 Kbytes single voltage Flash Program memory with read-out protection, In-Circuit and In-Application Programming (ICP and IAP). 10 K write/erase cycles guaranteed, data retention: 20 years at 55 °C.

– 128 bytes RAM.

– 128 bytes data EEPROM with read-out protection. 300K write/erase cycles guaranteed, data retention: 20 years at 55 °C.

• Clock, Reset and Supply Management

– 3-level low voltage supervisor (LVD) and aux- iliary voltage detector (AVD) for safe power- on/off procedures

– Clock sources: internal 1MHz RC 1% oscillator or external clock

– PLL x4 or x8 for 4 or 8 MHz internal clock

– Four Power Saving Modes: Halt, Active-Halt, Wait and Slow

• Interrupt Management

– 10 interrupt vectors plus TRAP and RESET

– 4 external interrupt lines (on 4 vectors)

• I/O Ports

– 13 multifunctional bidirectional I/O lines

– 9 alternate function lines

– 6 high sink outputs

• 2 Timers

– One 8-bit Lite Timer (LT) with prescaler including: watchdog, 1 realtime base and 1 input capture.

– One 12-bit Auto-reload Timer (AT) with output compare function and PWM

ST7FLITE09Y0B6 Applications

• Automobile engine control systems

• Implantable medical devices

• Remote controls

• Office machines

• Appliances