MC33078DT Overview
It is packaged in an 8-SOIC (0.154, 3.90mm Width)-case that protects the operational amplifiers from damage. A General Purpose-type buffer amplifier is shown here. A Cut Tape (CT) case is used to deliver the buffer op amp. The number of terminations is approaching the 8 mark. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. The buffer op amp includes 8 pins. Regarding input offset voltage, buffer amplifier rates 2mV voltage. Surface Mount is the recommended mounting type of operational amplifiers. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~105°C . You can run this op amp ic on 4mA . Maintain 100dB as the voltage gain. On the buffer amps, there are 2 channels that can be used. The operating supply voltage of the buffer op amp is rated at 15V. This linear amplifier pack is based on the TAPE AND REEL axis.
MC33078DT Features
8 Pins
supply voltage of 15V
100dB voltage gain
MC33078DT Applications
There are a lot of STMicroelectronics MC33078DT Instrumentational OP Amps applications.
- E-book readers
- Inverse/same-phase proportional circuit
- Cinema or auditorium audio system
- Image computer boards
- Video computer boards
- Video amplifiers
- Power transmission
- Signal amplification
- Automation control systems
- Measurements of Wheatstone bridge
