M74HCT174TTR Overview
The flip flop is packaged in 16-TSSOP (0.173, 4.40mm Width). It is included in the package Tape & Reel (TR). There is a Non-Invertedoutput configured with it. This trigger is configured to use Positive Edge. It is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. A temperature of -55°C~125°C TAis used in the operation. Logic flip flops of this type are classified as D-Type. It is a type of FPGA belonging to the 74HCT series. You should not exceed 56MHzin the output frequency of the device. The list contains 1 elements. T flip flop consumes 4μA quiescent energy. The number of terminations is 16. D latch belongs to the M74HCT174 family. Power is provided by a 5V supply. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This D flip flop belongs to the family of HCT. There is an electronic part that is mounted in the way of Surface Mount. A total of 16pins are provided on this board. This device has the clock edge trigger type of Positive Edge. This device has the base part number FF/Latches. It is designed with a number of bits of 6. Its superior flexibility is attributed to its use of 7 circuits. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. A total of 5V power supplies are needed to run it. In order to ensure high efficiency, the supply voltage should remain at 5V. It operates with 6 output lines.
M74HCT174TTR Features
Tape & Reel (TR) package
74HCT series
16 pins
6 Bits
5V power supplies
M74HCT174TTR Applications
There are a lot of STMicroelectronics M74HCT174TTR Flip Flops applications.
- Test & Measurement
- Instrumentation
- Communications
- Safety Clamp
- Counters
- Latch-up performance
- Control circuits
- High Performance Logic for test systems
- Shift registers
- Digital electronics systems
