LM258AWYST Overview
In order to protect the op amps, a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case is used. There are two types of operational amplifiers in this circuit. A Tape & Reel (TR) case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. Buffer amplifier has a total of 8 pins. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 5V. To be specific, this instrumentation amplifier is a type of Operational Amplifier. Regarding input offset voltage, buffer amplifier rates 1mV voltage. This electrical part should be mounted using type Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~105°C when it comes to operating temperatureAn 700μA volt supply current is needed for this linear amplifier to operate. On this buffer amplifier, there are 2 circuits. As a result of this, the buffer amplifier is packed in TAPE AND REEL. The Automotive, AEC-Q100 indicates the series number of the op amp.
LM258AWYST Features
8 Pins
supply voltage of 5V
LM258AWYST Applications
There are a lot of STMicroelectronics LM258AWYST Instrumentational OP Amps applications.
- single/dual op amp sum and difference circuits
- Signal transformation
- Measurements of Wheatstone bridge
- Differentiator circuits
- Hand-held batteries
- Wireless base stations
- Commercial audio systems
- Comparator
- Car stereo
- E-book readers
