LF253DT Overview
Packaging for the buffer amplifier is in the form of a 8-SOIC (0.154, 3.90mm Width) case. J-FET-type instrumentation amplifiers are used in this application. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 8. In total, there are 8 pins on this op amp ic. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 15V. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. The op amp ic has an array of 8 pins on it. The input offset voltage is 10mV. For this electronic part, it is recommended that you mount it with type Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~105°C . This op amp can operate from a supply current at 1.4mA. There should be no change in the voltage gain. This linear amplifier has a total of 2 elements. It is used TAPE AND REEL to pack the op amps.
LF253DT Features
8 Pins
supply voltage of 15V
106.02dB voltage gain
LF253DT Applications
There are a lot of STMicroelectronics LF253DT Instrumentational OP Amps applications.
- Wireless base stations
- Multiplication circuits
- Measurements of Wheatstone bridge
- Inverse/same-phase proportional circuit
- Radar
- Mobile phone
- Addition operation circuits
- Hand-held batteries
- Navigation
- Active probe
