74VHCT574ATTR Overview
It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). The Tape & Reel (TR)package contains it. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. In this case, the operating temperature is -55°C~125°C TA. This electronic flip flop is of type D-Type. JK flip flop belongs to the 74VHCTseries of FPGAs. Its output frequency should not exceed 130MHz Hz. In total, it contains 1 elements. During its operation, it consumes 4μA quiescent energy. Terminations are 20. The 74VHCT574family includes it. A voltage of 5V provides power to the D latch. This T flip flop has a capacitance of 4pF farads at the input. It is a member of the AHCT/VHCTfamily of D flip flop. The electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. The design is based on 8bits. Due to its superior flexibility, it uses 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. In order for the device to operate, it requires 5V power supplies. The flip flop contains 2ports. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It has 3 output lines to operate.
74VHCT574ATTR Features
Tape & Reel (TR) package
74VHCT series
20 pins
8 Bits
5V power supplies
74VHCT574ATTR Applications
There are a lot of STMicroelectronics 74VHCT574ATTR Flip Flops applications.
- CMOS Process
- Power down protection
- ESCC
- Counters
- Digital electronics systems
- Pattern generators
- Dynamic threshold performance
- Computers
- Safety Clamp
- Frequency division
