BU7264F-E2 Overview
A SOIC case is used to package the op amp. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. There have been a total of 14 terminations over the past year. The total number of pins on linear amplifier is 14. Please take in mind that this instrumentation amplifier should be run at 3V. Instrumentation amplifier is a part of Operational Amplifier. A total of 14 pins are present on the instrumentation amplifier. In terms of the input offset voltage, instrumentation amplifier rates at 1mV. An 550μA volt supply current is needed for this linear amplifier to operate. A linear amplifier like this has 4 circuits on it. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. At temperatures greater than 85°C, Instrumentation amplifier should not be used. As a result of this, the buffer amplifier is packed in TAPE AND REEL. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 5.5V. This op amp ic can conduct a minimum voltage gain of 3160.
BU7264F-E2 Features
14 Pins
supply voltage of 3V
BU7264F-E2 Applications
There are a lot of ROHM Semiconductor BU7264F-E2 Instrumentational OP Amps applications.
- Image computer boards
- Power transmission
- E-book readers
- Differentiator circuits
- Signal amplification
- Measurements of Wheatstone bridge
- Portable media players
- RF cable systems
- Vehicle electronics
- Industrial control system
