AD8370ARE-REEL7 Overview
Packaged in a 16-TSSOP (0.173, 4.40mm Width) Exposed Pad case, the buffer op amp is ready to use. Buffer amps of this type are called Variable Gain-types. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. It is estimated that there will be 16 terminations in the next few months. A total of 16 pins are located on this board. I would like to remind you that this buffer op amp should be powered by an 5V battery. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around -40°C~85°C . This op amp ic has 1 circuits. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Differential signals. To run supply current of buffer amplifier under 79mA. An analog IC that is also used in this instrumentation amplifier is referred to as the ANALOG CIRCUIT type.
AD8370ARE-REEL7 Features
16 Pins
supply voltage of 5V
Output Type: Differential
AD8370ARE-REEL7 Applications
There are a lot of Rochester Electronics, LLC AD8370ARE-REEL7 Instrumentational OP Amps applications.
- Automatic control
- Division circuits
- RF cable systems
- Inverse/same-phase proportional circuit
- Automation control systems
- Proportional counter tubes
- Fission chambers
- Strain gauges
- Switching amplifier
- Weak signal detection
