NLV74HC4852ADR2G Overview
The electronic component is convenient to ship overseas because it is packed in a 16-SOIC (0.154, 3.90mm Width). The advanced packaging method Tape & Reel (TR) provides high reliability. There is an analog multiplexer mounted in position Surface Mount. Multiplexer and demultiplexer circuits have a number 4:1. Operation at a temperature around -55°C~125°C TA. In total, there are 16 terminations. As a result of its 8 channels, this electronic component provides high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. A SP4T switching circuit is used for these analog switches. There are 2 circuits in this switch device. Try searching with MC74HC4852A if you're looking for variants. The internal resistance of this digital multiplexer is 400Ohm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 6V should not normally be supplied to the switches. An effective Single supply digital multiplexer. It is recommended to use 2V as the lowest voltage for the electrical part. It would be sufficient to run this analogue multiplexer with 2μA current. The voltage required by this switch device is 2V~6V, draining from a single voltage supply. There is an integrated analog IC DIFFERENTIAL MULTIPLEXER in the module. Automotive, AEC-Q100 is a series number.
NLV74HC4852ADR2G Features
8 Channels
Switch Circuit: SP4T
2μA Supply Current
NLV74HC4852ADR2G Applications
There are a lot of ON Semiconductor NLV74HC4852ADR2G Analog Switches & Multiplexers ICs applications.
- Fiber In The Loop (FITL)
- Microwave transmission systems
- Intelligent PBX
- Precision test equipment
- Battery-powered systems
- Digital Cross-Connects
- Precision data acquisition
- Medical systems
- Sample-and-hold systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
