NLAS4717EPFCT1G Overview
Packed in 10-UFBGA, FCBGA, the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature around -40°C~85°C TA extended. In total, 10 terminations have occurred. By its 2 channels, the electronic component provides high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. An injection of 10 pins is performed into the body of the electrical component. Circuits based on SPDT switching are used to construct these analog switch ics. Try searching with NLAS4717 to find analog multiplexer variants. Analog switches have 2.1Ohm internal resistance. For details about the functions of 10 pins, please refer to the datasheets. Multiplexer or Switches is a typical switch device. Multiplexers should not be powered above 5.5V in normal situations. A cost-effective Single supply type analogue multiplexer. 1.8V is the lowest voltage that should be fed to the electronic electronic part. This multiplexer would work with 1μA current. A voltage of 1.8V~5.5V is required for this switch device, which drains from a single voltage source. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. Operating voltages of 3V are compatible with the electrical part. A analog switch ics with 4 outputs is included.
NLAS4717EPFCT1G Features
2 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 90MHz
NLAS4717EPFCT1G Applications
There are a lot of ON Semiconductor NLAS4717EPFCT1G Analog Switches & Multiplexers ICs applications.
- Sample-and-hold systems
- Audio and video signal routing
- Battery Powered Systems
- Audio signal routing
- Isolation
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- ATM
- MP3 players
- Video switching
- DSLAMs
