MC74HCT374ADTR2 Overview
The item is packaged in 20-TSSOP (0.173, 4.40mm Width)cases. A package named Tape & Reel (TR)includes it. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. A temperature of -55°C~125°C TAis considered to be the operating temperature. This D latch has the type D-Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. This D flip flop should not have a frequency greater than 30MHz. The element count is 1 . There is 4μA quiescent consumption. Currently, there are 20 terminations. It is a member of the 74HCT374 family. It is powered by a voltage of 5V . JK flip flop input capacitance is 10pF farads. HCTis the family of this D flip flop. It is mounted by the way of Surface Mount. A total of 20pins are provided on this board. In this device, the clock edge trigger type is Positive Edge. It is included in FF/Latches. The flip flop is designed with 8bits. In order to achieve its superior flexibility, 8 circuits are used. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. A total of 5V power supplies are needed to run it. The D flip flop has no ports embedded. Optimal efficiency requires a supply voltage of 5V. There are no output lines on the JK flip flop.
MC74HCT374ADTR2 Features
Tape & Reel (TR) package
74HCT series
20 pins
8 Bits
5V power supplies
MC74HCT374ADTR2 Applications
There are a lot of ON Semiconductor MC74HCT374ADTR2 Flip Flops applications.
- Clock pulse
- Single Up Count-Control Line
- Registers
- 2 – Bit synchronous counter
- ESD protection
- ESD performance
- Event Detectors
- Divide a clock signal by 2 or 4
- Computers
- Counters
