MC74ACT377DWR2 Overview
It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). D flip flop is embedded in the Tape & Reel (TR) package. Currently, the output is configured to use Non-Inverted. In the configuration of the trigger, Positive Edgeis used. In this case, the electronic component is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at a temperature of -40°C~85°C TA. D-Typeis the type of this D latch. In terms of FPGAs, it belongs to the 74ACT series. Its output frequency should not exceed 140MHz. D latch consists of 1 elements. There is a consumption of 8μAof quiescent energy. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The 74ACT377 family contains it. It is powered by a voltage of 5V . Its input capacitance is 4.5pF farads. A device of this type belongs to the family of ACT. This RS flip flops is a part number FF/Latches. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). For normal operation, the supply voltage (Vsup) should be above 4.5V. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. The D latch runs on a voltage of 5V volts.
MC74ACT377DWR2 Features
Tape & Reel (TR) package
74ACT series
5V power supplies
MC74ACT377DWR2 Applications
There are a lot of ON Semiconductor MC74ACT377DWR2 Flip Flops applications.
- Data transfer
- Parallel data storage
- Guaranteed simultaneous switching noise level
- Storage Registers
- Circuit Design
- 2 – Bit synchronous counter
- Divide a clock signal by 2 or 4
- Common Clocks
- ATE
- Automotive
