MC100EL35DR2G Overview
The flip flop is packaged in 8-SOIC (0.154, 3.90mm Width). D flip flop is embedded in the Tape & Reel (TR) package. Differentialis the output configured for it. This trigger uses the value Positive Edge. Surface Mountmounts this electrical part. With a supply voltage of -4.2V~-5.7V volts, it operates. Temperature is set to -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop belongs to the 100ELseries of FPGAs. You should not exceed 2.2GHzin its output frequency. It consumes 32mA of quiescent A total of 8terminations have been recorded. This D latch belongs to the family of 100EL35. It is powered by a voltage of 5V . It is mounted by the way of Surface Mount. With its 8pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is part of the FF/Latchesbase part number family. The design is based on 2bits. It reaches the maximum supply voltage (Vsup) at 5.7V. Normally, the supply voltage (Vsup) should be kept above 4.2V. The superior flexibility of this product is achieved by using 1 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. It operates from +-5V power supplies. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop.
MC100EL35DR2G Features
Tape & Reel (TR) package
100EL series
8 pins
2 Bits
+-5V power supplies
MC100EL35DR2G Applications
There are a lot of ON Semiconductor MC100EL35DR2G Flip Flops applications.
- Set-reset capability
- Frequency Divider circuits
- Latch-up performance
- Test & Measurement
- Communications
- Bus hold
- Consumer
- Shift Registers
- Balanced 24 mA output drivers
- Convert a momentary switch to a toggle switch
