MC100EL31DG Overview
It is packaged in the way of 8-SOIC (0.154, 3.90mm Width). The Tubepackage contains it. It is configured with Differentialas an output. In the configuration of the trigger, Positive Edgeis used. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of -4.2V~-5.7V volts. In the operating environment, the temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. It is a type of FPGA belonging to the 100EL series. There should be no greater frequency than 2.8GHzon its output. During its operation, it consumes 32mA quiescent energy. In 8terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. D latch belongs to the 100EL31 family. Power is supplied from a voltage of 5V volts. The electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 8. This device has Positive Edgeas its clock edge trigger type. This RS flip flops is a part number FF/Latches. There are 1bits in this flip flop. It reaches the maximum supply voltage (Vsup) at 5.7V. For normal operation, the supply voltage (Vsup) should be kept above 4.2V. The superior flexibility is achieved through the use of 1 circuits. Considering its reliability, this T flip flop is well suited for RAIL. It runs on -4.5Vvolts of power. In addition to its maximum design flexibility, the output current of the T flip flop is 50mA. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop. A high level output current of 50mAis set. In the low level output current setting, 50mAis used.
MC100EL31DG Features
Tube package
100EL series
8 pins
1 Bits
-4.5V power supplies
MC100EL31DG Applications
There are a lot of ON Semiconductor MC100EL31DG Flip Flops applications.
- Reduced system switching noise
- Balanced Propagation Delays
- High Performance Logic for test systems
- Pattern generators
- Memory
- Storage Registers
- Digital electronics systems
- ATE
- 2 – Bit synchronous counter
- Count Modes
