LMV358DMR2G Overview
There is a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case package that contains the instrumentation amplifiers. A General Purpose-type buffer amplifier is shown here. A Tape & Reel (TR) case is used to deliver the buffer op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. As a reminder, this buffer op amp should be powered by 2.7V battery and that the battery should be inserted in the amplifier. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. 8 pins are located on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 9mV. For this electrical component, Surface Mount is the recommended mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . An 210μA volt supply current is needed for this linear amplifier to operate. It is recommended to keep the voltage gain at 100dB at all times. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. A voltage rating of 2 is indicated for the op amp's operating supply voltage. The operating supply voltage of instrumentation amplifier is rated 3V voltage. To pack the operational amplifier ics, TAPE AND REEL is adopted as the packing method.
LMV358DMR2G Features
8 Pins
supply voltage of 2.7V
100dB voltage gain
Output Type: Rail-to-Rail
LMV358DMR2G Applications
There are a lot of ON Semiconductor LMV358DMR2G Instrumentational OP Amps applications.
- Non-polarized electrodes
- RF cable systems
- Fission chambers
- Comparator
- Weak signal detection
- Instrumentation
- earphone
- ECG equipment
- Strain gauges
- Automation control systems
