KF353 Overview
There is a 8-DIP (0.300, 7.62mm) case package that contains the instrumentation amplifiers. This is a J-FET type op amp. A Tube case is used for delivering the op amp. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 10mV for this buffer op amp. Through Hole is the recommended mounting type of operational amplifiers. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. An 3.6mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain at 100dB. There are 2 circuits on this op amp. 2 channels are available on the instrumentation amplifier. It should not lower than 0°C to operate buffer amplifier. You should not use op amp above 70°C degrees. For the operating supply voltage of the op amp ic, there is a rating of 2. This electronic part is recommended to be used with an 3.6mA supply for best performance. This electrical part should be conducted under the dual supply voltage of 18V volts when you conduct this part.
KF353 Features
100dB voltage gain
KF353 Applications
There are a lot of ON Semiconductor KF353 Instrumentational OP Amps applications.
- Instrumentation
- Differentiator circuits
- Large motor controllers
- Voltage regulation circuit
- High input resistance broadband
- Portable electronic products powered by batteries
- Commercial audio systems
- E-book readers
- Blood pressure sensors
- Navigation
