I2781AG-08SR Overview
It is packaged using the Tape & Reel (TR) method since it is a clock IC. As part of the 8-SOIC (0.154, 3.90mm Width) package, this clock generator is embedded. There are 8 terminations found in this file. For this clock generator ic, a voltage of 3.3V is required. There is a Clock PLL called Clock, Crystal which is designed to be the input to this clock generator. An implementation of 1 circuits is required in order to fully utili1e the capabilities of the electrical part. RF synthesizers based on this clock provide frequencies up to 78MHz maximum. PLL clock is mounted in the way of Surface Mount. There are 3V~3.6V available for use with this clock PLL. The ambient temperature should be set at -40°C~85°C, which is estimated by the test statistics. I would like to present to you a frequency synthesizer that is compatible with Clock logic levels. This electronic component can be classified into Frequency Modulator, Spread Spectrum Clock Generator. Clock PLL is equipped with 8 pin count. The related electrical components for the base part number P278*A can be found below. In terms of the supply voltage, analog clock generator can handle 3.3V volts.
I2781AG-08SR Features
Available in the 8-SOIC (0.154, 3.90mm Width)
Supply voltage of 3.3V
Operating supply voltage of 3.3V
I2781AG-08SR Applications
There are a lot of ON Semiconductor I2781AG-08SR Clock Generators applications.
- Peripheral devices
- FSK demodulators
- High-frequency induction heating
- Microwave radio
- Skew suppression
- Clock recovery
- Microprocessor clock multipliers
- Carrier synchronization in wired communication
- Satellite receivers
- Test equipment
