DM74ALS174MX Overview
It is packaged in the way of 16-SOIC (0.154, 3.90mm Width). D flip flop is included in the Tape & Reel (TR)package. T flip flop uses Non-Invertedas its output configuration. Positive Edgeis the trigger it is configured with. Surface Mountis occupied by this electronic component. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. JK flip flop belongs to the 74ALSseries of FPGAs. In order for it to function properly, its output frequency should not exceed 50MHz. D latch consists of 1 elements. This process consumes 19mA quiescents. The object belongs to the 74ALS174 family. The electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 16. This device's clock edge trigger type is Positive Edge. 6bits are used in its design. The superior flexibility of this product is achieved by using 7 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. In order for the chip to function, it has 2output lines. It has 3lines. In this case, the high level output current is set to -400μA. In the low level output current setting, 8mAis used. There should be a temperature below 70°Cduring operation. It is recommended that the operating temperature be greater than 0°C. Despite its minimal supply voltage of 4.5V, it is capable of operating. A maximum voltage of 5.5V can be provided by it. This frequency can be achieved 50MHz.
DM74ALS174MX Features
Tape & Reel (TR) package
74ALS series
16 pins
6 Bits
DM74ALS174MX Applications
There are a lot of ON Semiconductor DM74ALS174MX Flip Flops applications.
- Divide a clock signal by 2 or 4
- Registers
- High Performance Logic for test systems
- Digital electronics systems
- ESD protection
- Bounce elimination switch
- Reduced system switching noise
- Matched Rise and Fall
- Buffer registers
- Pattern generators
