74LVTH273SJX Overview
The flip flop is packaged in 20-SOIC (0.209, 5.30mm Width). D flip flop is embedded in the Tape & Reel (TR) package. This output is configured with Non-Inverted. The trigger it is configured with uses Positive Edge. Surface Mountis positioned in the way of this electronic part. The supply voltage is set to 2.7V~3.6V. It is operating at a temperature of -40°C~85°C TA. It is an electronic flip flop with the type D-Type. The 74LVTHseries comprises this type of FPGA. A frequency of 150MHzshould not be exceeded by its output. D latch consists of 1 elements. It consumes 190μA of quiescent current without being affected by external factors. JK flip flop belongs to 74LVTH273 family. This JK flip flop has a 3pFfarad input capacitance. A part of the electronic system is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. There is a clock edge trigger type of Positive Edgeon this device. The flip flop is designed with 8bits. In order to achieve its superior flexibility, 8 circuits are used. For high efficiency, the supply voltage should be kept at 3.3V. To operate, the chip has a total of 7 output lines. A total of 4input lines have been provided. A high level output current of -32mAis set. There is no low level output current set at 64mA. Operating temperatures should be lower than 85°C. Temperatures above -40°Cshould be used. Initially, it requires a voltage of 2.7V as the minimum supply voltage. 3.6Vis the maximum supply voltage supported by it. It is possible to achieve 150MHz frequencies.
74LVTH273SJX Features
Tape & Reel (TR) package
74LVTH series
20 pins
8 Bits
74LVTH273SJX Applications
There are a lot of ON Semiconductor 74LVTH273SJX Flip Flops applications.
- Modulo – n – counter
- Guaranteed simultaneous switching noise level
- 2 – Bit synchronous counter
- Load Control
- Reduced system switching noise
- Single Down Count-Control Line
- Digital electronics systems
- Buffer registers
- Balanced 24 mA output drivers
- Set-reset capability
