74F109SC Overview
16-SOIC (0.154, 3.90mm Width)is the way it is packaged. The package Tubecontains it. There is a Differentialoutput configured with it. The trigger configured with it uses Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. The operating temperature is 0°C~70°C TA. There is JK Type type of electronic flip flop associated with this device. In FPGA terms, D flip flop is a type of 74Fseries FPGA. A frequency of 125MHzshould be the maximum output frequency. A total of 2elements are contained within it. As a result, it consumes 17mA of quiescent current without being affected by external factors. Members of the 74F109family make up this object. There is an electronic component mounted in the way of Surface Mount. A total of 16pins are provided on this board. This device's clock edge trigger type is Positive Edge. An electronic part with 2bits has been designed. Its superior flexibility is attributed to its use of 2 circuits. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. To operate, the chip has a total of 3 output lines. As of now, there are 2input lines. A high level output current of -1mAis set. In the low level output current setting, the current is set to 20mA. If the operating temperature is lower than 70°C, it is recommended. Temperatures above 0°Cshould be used. Initially, it requires a voltage of 4.5V as the minimum supply voltage. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 125MHz.
74F109SC Features
Tube package
74F series
16 pins
2 Bits
74F109SC Applications
There are a lot of ON Semiconductor 74F109SC Flip Flops applications.
- Frequency Divider circuits
- Divide a clock signal by 2 or 4
- Reduced system switching noise
- Count Modes
- Data storage
- Load Control
- QML qualified product
- Data Synchronizers
- Counters
- Convert a momentary switch to a toggle switch
