NJM2114M-TE3 Overview
There are two types of operational amplifiers in this circuit. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 3mV. 110dB should remain the voltage gain. Buffer op amp is equipped with 2 channels on the device. It is recommended that the temperature of this op amp ic should not fall below -20°C degrees Fahrenheit at any time. Instrumentation amplifier shouldn't be used above 75°C . The operating supply voltage of the buffer op amp is rated at 22V. As a result of this, the buffer amplifier is packed in TAPE AND REEL. It is recommended that you conduct this electronic part using the dual supply voltage of 22V.
NJM2114M-TE3 Features
8 Pins
supply voltage of 15V
110dB voltage gain
NJM2114M-TE3 Applications
There are a lot of New Japan Radio (NJR)
NJM2114M-TE3 Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
