NJM064V-TE2 Overview
In the package, you will find a SSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 15V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. Op amp rates 15mV as input offset voltage. You should keep the voltage gain at 80dB for the time being. On the buffer amps, there are 4 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. The operating supply voltage of the buffer op amp is rated at 18V. This electrical part should be conducted under the dual supply voltage of 18V volts when you conduct this part.
NJM064V-TE2 Features
14 Pins
supply voltage of 15V
80dB voltage gain
NJM064V-TE2 Applications
There are a lot of New Japan Radio (NJR)
NJM064V-TE2 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
