TCM810LENB713 Overview
Power management is mounted through 3 terminals. A Cut Tape (CT) package is used to package the power management. Please refer to this PMIC for 1 functions. Depending on the power managment ic you are looking at, you can find a total of 1 channels. Please find attached TO-236-3, SC-59, SOT-23-3 functions for your reference in this IC power. Compared to other Simple Reset/Power-On Reset products, this PMIC has a lot of benefits to offer. Specifies a reflow peak temperature of 260 for the package during reflow. IC management conducts at a voltage of 5V. When 1 is applied to the power ic, it conducts. The mount is provided by Surface Mount. In this case, this PMIC chip can be sub-categorized as a Power Management Circuits chip. 3 pins are present in total in this power management. Pin count of the power management is 3. I should note that the minimum supply voltage (Vsup) for this IC management should be at least 1V, which is the minimum supply voltage that should be applied. In this PMIC, the maximum supply voltage (Vsup) should not exceed 5.5V volts. A Surface Mount mounting type is recommended. Temperature setting for the supervisors should be -40°C~85°C TA. As a result of this supervisor's operation, the output voltage is Push-Pull, Totem Pole. Supplied with a operating current of 12μA, this PMIC is capable of fully function as specified. A similar IC managements number of the manufacturer can always be found by using TCM810, the base power ics number.
TCM810LENB713 Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
12μA operating supply current
TCM810LENB713 Applications
There are a lot of Microchip Technology TCM810LENB713 Voltage Supervisors applications.
- Detection of phase loss
- Urban rail transit weak current power monitoring
- Battery cars
- Important electronics for automotive safety
- Leakage current detection
- Dash board
- Battery-powered equipment
- Embedded computing
- Electric heating appliances
- Microcontroller system
