MCP6044-I/P Overview
It is packaged in an 14-DIP (0.300, 7.62mm)-case that protects the operational amplifiers from damage. A General Purpose-type buffer amplifier is shown here. The op amp is delivered to you in a Tube case. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. The linear amplifier should be run at 5V at all times, so please keep that in mind when using it. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 14 pins are included on the operational amplifiers. Op amp rates 3mV as input offset voltage. It is recommended that this electronic component be mounted using the Through Hole mounting type. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~85°C. It is a member of the 115dB's 115dB family. The op amp ic has 4 channels on it. As one of the many benefits of this buffer amplifier, it puts out Rail-to-Rail signals, which is one of the many benefits it offers. The operating supply voltage of the buffer op amp is rated at 5.5V. It is recommended that this electronic component be used with an 600nA supply.
MCP6044-I/P Features
14 Pins
supply voltage of 5V
115dB voltage gain
Output Type: Rail-to-Rail
MCP6044-I/P Applications
There are a lot of Microchip Technology MCP6044-I/P Instrumentational OP Amps applications.
- ECG equipment
- Polarized electrodes
- Video data acquisition
- Measurements of Wheatstone bridge
- Medical instruments
- Vehicle electronics
- Signal amplification
- Weak signal detection
- Proportional counter tubes
- Automotive sensors
