MCP6032-E/MS Overview
There is a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case package that contains the instrumentation amplifiers. The instrumentation amplifier in this picture is of the General Purpose-type. It comes in a Tube case, which protects instrumentation amplifier from damage during delivery. It is estimated that there will be 8 terminations in the next few months. A total of 8 pins are attached to buffer op amp. The linear amplifier should be run at 1.8V at all times, so please keep that in mind when using it. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. An 8-pin op amp ic is included in the package. As far as the input offset voltage is concerned, linear amplifier rates at 150μV. For this electrical component, Surface Mount is the recommended mounting type. According to the manufacturer, this buffer op amp works well at -40°C~125°C , which is a good operating temperature. An 900nA volt supply current is needed for this linear amplifier to operate. Voltage gain should remain at 115dB. The op amp ic has 2 channels on it. A benefit of this op amp ic is that it outputs Rail-to-Rail signals, which is one of the many advantages it has to offer.
MCP6032-E/MS Features
8 Pins
supply voltage of 1.8V
115dB voltage gain
Output Type: Rail-to-Rail
MCP6032-E/MS Applications
There are a lot of Microchip Technology MCP6032-E/MS Instrumentational OP Amps applications.
- Proportional operation circuits
- Oscilloscopes
- Fission chambers
- High/low-pass filter circuit
- Broadcasting
- Portable media players
- Blood pressure sensors
- Signal operation
- Weak signal detection
- Integrator circuits
