MAX6387LT28D1+T Overview
A total of 6 terminals are used to mount this power management. Tape & Reel (TR)-packaging is used. The purpose of this IC management is to provide you with a reference of 1 functions. A series of 1 channels can be found on this supervisor. In this IC management you will find WFDFN functions for you to refer to. There are a lot of similarities between this IC management and other Multi-Voltage Supervisor products. Packages are specified to have an average peak reflow temperature of 260. The supervisor is always powered by a 1.8V volt supply. Power ics operate at 2 supply voltages. Surface Mount mounts IC management. The power management system can be categorized as a Power Management Circuits chip. 6 pins are present in total in this power management. Pin count of the power management is 6. I should note that the minimum supply voltage (Vsup) for this IC management should be at least 1V, which is the minimum supply voltage that should be applied. During this IC power, the maximum supply voltage (Vsup) should not exceed 5.5V volts. There is a 7μA supply current present in the power management.
MAX6387LT28D1+T Features
Multi-Voltage Supervisor type
Minimum supply voltage of 1V
7μA operating supply current
MAX6387LT28D1+T Applications
There are a lot of Maxim Integrated MAX6387LT28D1+T Voltage Supervisors applications.
- Stable power system
- Magnetic resonance imaging
- Transformer load monitoring equipment
- Digitally controlled LDO regulators circuit
- Detection of phase loss
- FPGA design
- Important electronics for automotive safety
- Battery cars
- Radar
- Automotive permanent magnet synchronous motors
