MAX4701EUE+T Overview
Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:2. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 2 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. A DPDT switching circuit is used to build these analog multiplexers. There are 2 circuits in this multiplexer. Try searching with MAX4701 if you're looking for variants. There is 75Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. 1.8V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. 5V operating voltages are supported by the electronic component.
MAX4701EUE+T Features
2 Channels
Switch Circuit: DPDT
1μA Supply Current
-3db Bandwidth: 250MHz
MAX4701EUE+T Applications
There are a lot of Maxim Integrated
MAX4701EUE+T Analog Switches & Multiplexers ICs applications.
- Transmit
- Low-Voltage
- Isolation
- Medical
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
