MAX4677EUE+T Overview
Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. 16 terminations have been made so far. A high-quality output is provided by the electrical component's 1 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. Unlike digital switches, these are based on SPST - NC switching circuits. Circuits number 4 make up this analogue multiplexer. Try searching with MAX4677 to find analog multiplexer variants. An switch multiplexer with 1.6Ohm internal resistance has a value of 1.6Ohm. The functions of 16 pins can be found in the datasheets. Users shouldn't supply more than 11V voltage to the switch device. Dual, Single supply type digital switch with a low cost. It is recommended to use 2.7V as the lowest voltage for the electrical part. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. If put voltage greater than 5.5V on the multiplexer, damage may be caused to the device. It is recommended that you attach at least 2.7V to your dual power supply. This electrical part is compatible with 5.5V operating voltages.
MAX4677EUE+T Features
1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 66MHz
MAX4677EUE+T Applications
There are a lot of Maxim Integrated MAX4677EUE+T Analog Switches & Multiplexers ICs applications.
- Avionics
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Precision test equipment
- Audio signal routing
- FTTH
- Cable PC
- Data switching
- Private Branch Exchange (PBX)
- Sample hold systems
- Video signal routing
