MAX4541EKA-T Overview
Due to its SOT-23-8 packaging, the electronic part is convenient for international shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operating temperature extended to -40°C~85°C TA. In total, there are 8 terminations. High-quality output is provided by the electronic component's 2 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. This electronic part can be found in the 8 series. A SPST - NO switching circuit is used for these analog switches. Look for analog switch ic variants by searching with MAX4541. There is 60Ohm internal resistance in this digital multiplexer. You can find the functions of the 8 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 12V volts for the multiplexer. The digital multiplexer has a low cost Single supply. The lowest voltage the electronic part should receive is 2.7V. This multiplexer would work with 100pA current. A voltage of 2.7V~12V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. A total of SEPARATE OUTPUT outputs are available on this analog switch ic.
MAX4541EKA-T Features
2 Channels
Switch Circuit: SPST - NO
100pA Supply Current
MAX4541EKA-T Applications
There are a lot of Maxim Integrated MAX4541EKA-T Analog Switches & Multiplexers ICs applications.
- DSLAMs
- Fiber In The Loop (FITL)
- Relay Replacement
- Routers
- HDTV
- Private Branch Exchange (PBX)
- Channel Banks
- 65 V DACs
- PCMCIA cards
- Precision test equipment
