MAX4528ESA+T Overview
The electrical component comes in 8-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Operating temperature extended to -40°C~85°C TA. Totally, there are 8 terminations. A electrical component with 2 channels is capable of high-quality output. When a voltage supply of 5V is used, the electronic component should be turned on and run. This electronic part can be found in the 8 series. These analog multiplexers are built based on SPDT switching circuits. Circuits number 2 make up this analogue multiplexer. Try searching for the analog switch ic with MAX4528 if you are looking for variants. In this multiplexer, the internal resistance is 110Ohm. It is generally not recommended to supply a voltage higher than 12V to the switch device in normal circumstances. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 2.7V voltage fed to the electrical part below 2.7V. An operating current of 1μA would be sufficient for this switch device. Putting voltage greater than 1μA on the multiplexer may cause damage. For this multiplexer, dual supply voltage is feasible, but it should not exceed 6V. If you are using dual power supplies, you should attach at least 2.7V. There is an analog IC DPDT integrated with this board. It can operate from 6V operating voltages.
MAX4528ESA+T Features
2 Channels
Switch Circuit: SPDT
1μA Supply Current
MAX4528ESA+T Applications
There are a lot of Maxim Integrated MAX4528ESA+T Analog Switches & Multiplexers ICs applications.
- Relay replacements
- Avionics and Military Systems
- Industrial control systems
- Cable Modem
- E1 Network Equipment
- Automotive applications
- PCMCIA cards
- DSUs
- Routers
- Voice over IP/DSL – Integrated Access Devices, Smart
