MAX4514CUK-T Overview
This electronic part is conveniently packaged in SC-74A, SOT-753, making it easy to ship abroad. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a number of circuits 1:1. The operating temperature is extended to around 0°C~70°C TA. 5 terminations have been made so far. A electrical component with 1 channels is capable of high-quality output. If the voltage supply is 12V volts, the electrical component should be turned on and run. There is an electrical component included in the 5 series. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with MAX4514 if you're looking for variants. As far as internal resistance is concerned, it has 20Ohm. The functions of 5 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 12V. An effective Single supply digital multiplexer. 2V should be the lowest voltage fed to the electronic component. 1μA current would be enough for this multiplexer to operate. The voltage required by this switch device is 2V~12V, draining from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 1μA. The electrical part can be operated at 9V voltage levels.
MAX4514CUK-T Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
MAX4514CUK-T Applications
There are a lot of Maxim Integrated MAX4514CUK-T Analog Switches & Multiplexers ICs applications.
- E1 Multiplexer
- Battery Powered Systems
- Digital cross connects (DSX-1)
- Digital access cross connects
- Microwave transmission systems
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Power routing
- Multi-Line E1 Interface Cards
- Cellular phones
- Public switching systems
