MAX4501EXK-T Overview
Shipping overseas is convenient due to the electrical component's packing in 5-TSSOP, SC-70-5, SOT-353. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 1:1 is the number of circuits in the multiplexer and demultiplexer. The operating temperature is extended to around -40°C~85°C TA. Total terminations are 5. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 5V is used, the electronic component should be turned on and run. The electrical component body receives 5 pins. These analog multiplexers are built based on SPST - NO switching circuits. The multiplexer consists of 1 circuits. Try searching with MAX4501 if you're looking for variants. In this multiplexer, the internal resistance is 250Ohm. To find out what the 5 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 12V volts for the multiplexer. A analog switch ic that has a cost-effective Single supply type. 2V is the lowest voltage the electrical component should receive. For this multiplexer to operate, 1μA current would be sufficient. This analog switch requires a voltage of 2V~12V to drain from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. Operating voltages of 9V are compatible with the electrical part.
MAX4501EXK-T Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
MAX4501EXK-T Applications
There are a lot of Maxim Integrated MAX4501EXK-T Analog Switches & Multiplexers ICs applications.
- Cell phones
- High speed data transmission line cards
- DSLAMs
- Routers
- Microprocessor Controlled Analog Systems
- Automotive applications
- CSU
- Fiber In The Loop (FITL)
- PCMCIA cards
- PBX interfaces
