MAX4383EEE+T Overview
In the package, you will find a QSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. During the past two weeks, there have been close to 16 terminations. A total of 16 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 16 pins on it. Op amp rates 3mV as input offset voltage. Using an 7.5mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 63dB for the time being. On the buffer amps, there are 4 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. The operating supply voltage of the buffer op amp is rated at 9V. This electric component can work from a voltage of under 11V as far as supply voltage is concerned. A voltage of 4.5V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 5.5V volts when you conduct this part.
MAX4383EEE+T Features
16 Pins
supply voltage of 5V
63dB voltage gain
MAX4383EEE+T Applications
There are a lot of Maxim Integrated
MAX4383EEE+T Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
