MAX410CSA+T Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp of this type is a General Purpose-type. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. It is estimated that there will be 8 terminations in the next few months. A total of 8 pins are attached to buffer op amp. I would like to remind you that this buffer op amp should be powered by an 5V battery. It should be noted that this op amp is a type of Operational Amplifiers device. Regarding input offset voltage, buffer amplifier rates 120μV voltage. The mounting type that is recommended for this electrical part is Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of 0°C~70°C. It is possible to operate this buffer amplifier from a supply current of 2.5mA . 122dB should remain the voltage gain. In total, there are 1 circuits on this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 5.25V. It is used TAPE AND REEL to pack the op amps.
MAX410CSA+T Features
8 Pins
supply voltage of 5V
122dB voltage gain
MAX410CSA+T Applications
There are a lot of Maxim Integrated MAX410CSA+T Instrumentational OP Amps applications.
- Proportional operation circuits
- Fission chambers
- Automation control systems
- Signal amplification
- Mobile phone
- Tablets
- Automotive sensors
- Oscilloscopes
- Vehicle electronics
- High speed sample
