MAX333EWP+T Overview
As the electronic part is packed in 20-SOIC (0.295, 7.50mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 20. The electronic part provides high-quality output because it has 1 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. The electrical component body receives 20 pins. Circuits based on SPDT switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with MAX333 to find analog multiplexer variants. An switch multiplexer with 35Ohm internal resistance has a value of 35Ohm. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 30V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 10V. An operating current of 1μA would be sufficient for this switch device. When the digital multiplexer is charged above 50μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 18V. It is recommended that you attach at least 5V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. 20V operating voltages can be used with this electrical part.
MAX333EWP+T Features
1 Channels
Switch Circuit: SPDT
1μA Supply Current
MAX333EWP+T Applications
There are a lot of Maxim Integrated
MAX333EWP+T Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
