MAX314FESE+ Overview
Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tube. Mounted in Surface Mount is this multiplexer. There is 1:1 ratio between the number of multiplexers and demultiplexers. The operating temperature is extended to around -40°C~85°C TA. In total, there have been 16 terminations. By its 1 channels, the electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. There is an electrical component included in the 16 series. Based on SPST - NO/NC switching circuits, these analog multiplexers work. A 4 circuit is present in this switch device. Try searching with MAX314 if you're looking for variants. In this multiplexer, the internal resistance is 10Ohm. The functions of 16 pins can be found in the datasheets. Users should never supply a voltage higher than 36V to a switch device. The digital multiplexer has a low cost Dual, Single supply. A low voltage of 9V should be applied to the electronic component. If you put voltage higher than 500μA on the digital multiplexer, damage may occur. Despite this switch device's dual supply capability, its voltage should not exceed 20V. For dual power supplies, a voltage of at least 4.5V should be attached. The electrical part can be operated at 20V voltage levels.
MAX314FESE+ Features
1 Channels
Switch Circuit: SPST - NO/NC
MAX314FESE+ Applications
There are a lot of Maxim Integrated MAX314FESE+ Analog Switches & Multiplexers ICs applications.
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Fiber In The Loop (FITL)
- Audio signal routing
- High speed data transmission line cards
- Audio and video switching
- Fault Tolerant Systems
- Mechanical reed relay replacement
- Battery Powered Instruments
- PBX interfaces
- Precision instrumentation
